Projects / Software · In progress

Printdeck OS

The software side of Printdeck: the Klipper host, ported to Go, with a touch screen, in a read-only Linux image for the Raspberry Pi 5.

Host
Klipper in Go
Board
Raspberry Pi 5
Image
Read-only, A/B
License
AGPL-3.0

Overview

Printdeck is a touch screen and print server for Klipper printers. The Printdeck build is the hardware: a desk case for a Raspberry Pi 5 and a 5-inch display. This page is the software.

One Go program, printdeck, does the work. It is the Klipper host, ported from Python to Go, in one static file. It draws the touch screen straight to the display, and it serves the same screens to a browser. It serves the OctoPrint API, so Cura, PrusaSlicer, and OrcaSlicer send files to it.

The Pi runs Printdeck OS from the microSD card. It is a small read-only Linux system with the printdeck program, Wi-Fi, mDNS (printdeck.local), and NTP. Buildroot makes it from source. The system has two slots, and an update writes the other slot.

The screens

Screens from the demo mode of the deck. The deck UI in the documentation shows every screen.

Printing

  • The idle screen with the status display, Print a file, and the pages
  • The list of files with the print time and the filament of each
  • A print with the model up to the layer that prints now
  • Tune with the speed, the flow, the Z offset, and the fan

Setup

  • Step 1 of the first setup: the Wi-Fi networks
  • The printer setup with the board that the deck found on USB
  • The deck writes the Klipper firmware to the board
  • Software update with the versions and the notes