Reference
Hardware lists
The parts, the screws and the inserts of the Slate v4 and the pod.
The connections
The Slate v4 is a Raspberry Pi Touch Display 2 (5 inch, tall) with a Raspberry Pi 5 on its back, in a printed case on the desk. The case is navy, and it stands on an orange base. Two M3 screws hold the case on the base. lulzbot/stl/slate/README.md has the print files, the hardware and the assembly. The Slate v4 replaces the pod on a printer bracket. lulzbot/README.md has the pod as an earlier design.
| Part | Connection |
|---|---|
| Raspberry Pi 5 | Raspberry Pi 27 W USB-C power supply |
| Raspberry Pi Active Cooler | Fan connector of the Pi |
| Raspberry Pi Touch Display 2, 5 inch | DSI ribbon, and a power wire to the GPIO header of the Pi |
| SD card | Boot device |
| USB-A to USB-B cable | The board of the printer |
What you need
From lulzbot/README.md. The hardware page has the Slate v4, and the pod with its brackets on each printer.
- A Raspberry Pi Touch Display 2, 5 inch. Its box has the DSI ribbon, the power wire and the M2.5 screws.
- A Raspberry Pi 5 with the Raspberry Pi Active Cooler.
- An SD card for Printdeck OS. See Install.
- The Raspberry Pi 27 W USB-C power supply.
- A USB cable from USB-A to USB-B, from the Pi to the printer.
- The printed parts and the hardware in stl/slate/README.md.
The hardware of the Slate v4
From lulzbot/stl/slate/README.md. The print page has the print files and the assembly.
| Part | Count | Where |
|---|---|---|
| M2.5 x 4 screw | 8 | In the box of the display: 4 hold the Pi on the standoffs, 4 hold the display in the case |
| M3 x 8 cap screw | 2 | From behind, through the boss of the base and the back of the body, into the nuts |
| M3 hex nut (5.5 mm across the flats, 2.4 mm thick) | 2 | Pressed into the two rings on the inner floor of the body |
| M3 x 6 cap screw | 4 | FDM only: down the posts of the body into the frame |
| M3 heat-set insert, 4 mm long | 4 | FDM only: in the bosses of the frame. Press each insert flush with the face. |
| Rubber foot, 10 mm across or less | 4 | Under the corners of the foot |
The hardware of the pod
From lulzbot/stl/pod/README.md. The pod page has the print files.
| Part | Count | Where |
|---|---|---|
| M2.5 x 4 screw | 8 | In the box of the display: 4 hold the frame to the display, 4 hold the Pi |
| M3 heat-set insert, 4 mm long | 6 | FDM parts only: 4 in the bosses of the frame, 2 in the mount. Press each insert flush with the face. |
| M3 x 6 cap screw | 6 | 4 down the posts of the body into the frame, 2 from inside the body into the mount |
| M3 hex nut (5.5 mm across the flats, 2.4 mm thick) | 6 | Resin parts only, in place of the 6 heat-set inserts |